Location:Home / News / Do precision filters need to be cleaned in time?
The precision filter needs to be cleaned in time for the following reasons:
1. The core part of the precision filter is the filter element. The filter element consists of a filter frame and a stainless steel wire mesh. Stainless steel wire mesh is a wear-resistant part and requires special protection
2. After the filter works for a period of time, certain impurities will be deposited in the filter element. At this point, the pressure drop increases and the flow decreases. The impurities in the filter element should be timely;
3. When cleaning impurities, pay special attention to the stainless steel wire mesh on the filter element not to be deformed or damaged, otherwise the filter will be installed, and the purity of the filter medium will not meet the design requirements. destroy
4. If the stainless steel wire mesh is found to be deformed or damaged, it needs to be replaced immediately.
Precision filter: a. The core of the precision filter is the filter element. The filter element is made of special material and is a suitable damage part. It needs special protection. B After the precision filter works for a period of time, the filter element contains a certain amount. At this point, the pressure drop increases and the flow decreases. It is necessary to clean up impurities in the filter in time, and clean the filter element at the same time. C When removing impurities, special attention should be paid to the precision filter element, which must not be deformed or damaged, otherwise the installed filter element and the purity of the filtered medium will not meet the design requirements.
Products
NEWS
Contact us
152 5863 6575
Consulting service hotlineCopyright ? 2022 WENZHOU REJIA VALVE CO., LTD. .All Right Reseved